6
1.5
Dial Switch Setup (HDCVI Intelligent Speed Dome)
Remove the bracket component; you can see there are two dial switch buttons on the PTZ
mainboard. You can use them to set intelligent speed dome address, baud rate, HD/SD video
format and etc.
1.5.1 Initial Setup
Address: 1
Baud rate: 9600
HD/SD video format setup: HD
120
Ω
matched resistance
：
OFF
1.5.2 Dial Switch Setup for Intelligent Speed Dome
Users must set the address, Baud rate and HD/SD video format which are used by the speed
dome before controlling it. Only after all these setup, can the speed dome respond to its control
commands.
Note:
Users must reboot the speed dome after resetting some specifications, which makes the new
setup take effect.
There are two dial switch buttons on the speed dome PTZ which are used to confirm the
specifications of address and Baud rate, HD/SD video format. It is 1 when you set the button as
ON. For address setup dial, 1 is the lowest bit, 8 is the highest bit; for the Baud rate and HD/SD
video format setup dial, 1 is the lowest bit, 4 is the highest bit, see Figure 1-9. (Intelligent speed
dome self-adapt PELCO-D, PELCO-P, industrial standard protocol, control protocol doesn
’t need
to be set via dial).
Figure 1-9
1.5.3 Baud rate and HD/SD Video Format Setup
It is used to set speed dome Baud rate and parity. 1 and 2 bits are used to set Baud rate while 3
and 4 bits are used to set HD/SD video format setup, see Figure 1-10.
Summary of Contents for DH-SD60230U-HNI
