Dahua DH-IPC-HFW2X-W, Quick Start Manual

Page: 5 / 19

Quick Start Guide
IV
⚫
It is recommended to ground the device to enhance reliability.
⚫
Do not touch the image sensor (CMOS) directly. Dust and dirt can be removed with air blower,
or you can wipe the lens gently with soft cloth that is moistened with alcohol.
⚫
You can clean the device body with soft dry cloth, and for stubborn stains, use the cloth with
mild detergent. To avoid possible damage on device body coating which could cause
performance decrease, do not use volatile solvent such as alcohol, benzene, diluent to clean
the device body, nor can strong, abrasive detergent be used.
⚫
Dome cover is an optical component. Do not touch or wipe the cover with your hands directly
during installation or operation. For removing dust, grease or fingerprints, wipe gently with
moistened oil-free cotton with diethyl or moisten soft cloth. You can also remove dust with an air
blower.
⚫
Strengthen the protection of network, device data and personal information by adopting
measures which include but not limited to using strong password, modifying password regularly,
upgrading firmware to the latest version, and isolating computer network. For some devices
with old firmware versions, the ONVIF password will not be modified automatically along with
the modification of the system password, and you need to upgrade the firmware or manually
update the ONVIF password.
⚫
Use standard components or accessories provided by manufacturer and make sure that the
device is installed and maintained by professional engineers.
⚫
The surface of the image sensor should not be exposed to laser beam radiation in an
environment where a laser beam device is used.
⚫
Do not provide two or more power supply sources for the device unless otherwise specified. A
failure to follow this instruction might cause damage to the device.
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body. RF Exposure: A distance of 20cm shall be maintained between the antenna and users, and
the transmitter module may not be co-located with any other transmitter or antenna.
Federal Communication Commission Interference Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this