100
Figure 5-34
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
You need to check the box to enable this function.
Please select a channel from the dropdown list.
Period
This function becomes activated in the specified periods.
There are six periods in one day. Please draw a circle to
enable corresponding period.
Select date. If you do not select, current setup applies to
today only. You can select all week column to apply to the
whole week.
Click OK button, system goes back to local alarm
interface, please click save button to exit.
Type
Normal open or normal close.
Trigger
Here is for you to set activation mode. There are two options:
High/low.
Overlay
Please highlight the box here to enable this function. It can
overlay alarm information on the video screen when an alarm
occurred.
Anti-dither
System only memorizes one event during the anti-dither
period. The value ranges from 5s to 600s.
Record channel
System auto activates channel(s) to record once an alarm
occurs. Please note you need to set alarm record period
and go to Storage-> Schedule to set current channel as
schedule record.
Record Delay
System can delay the record for specified time after alarm
ended. The value ranges from 10s to 300s.
Alarm out
Enable alarm activation function. You need to select alarm
output port so that system can activate corresponding
alarm device when an alarm occurs.
Latch
System can delay the alarm output for specified time after
an alarm ended. The value ranges from 1s to 300s.
