10
3.2
Wall Mount Installation Steps
3.2.1 Installation Environments
The wall mount speed dome can be installed in the hard construction wall in the indoor or
outdoor environments. Before the installation, please make sure:
The wall is thick enough to install the expansion bolt.
The ceiling can at least sustain the 8x weight of the speed dome, bracket and the
accessories.
3.2.2 Installation Steps
Step 1
Draw the punch positions on the wall according to the installation holes on the bottom of the wall
mount bracket (align the bracket cable outlet hole with the round hole on the wall), and dig holes
on the wall, then insert the expansion bolts into the holes which were just dug (expansion bolts
are prepared by users themselves).
Step 2
As it is shown in Figure 3-3, lock the safety buckle well; insert the combination cable of the speed
dome from the adapter and pull it out from the other end of the wall mount bracket, then aim the
enclosure top connecting flange at the inner holes of the adapter, push the speed dome to the
bottom and tighten the three screws completely just in case the speed dome falls if it is not
installed properly.
Figure 3-3
Step 3
Insert the combination cable into the wall holes after it is connected respectively, and then use
four hex nuts and flat gasket to fix the wall mount bracket on the wall where expansion bolts are
already inserted, see Figure 3-4.
