Owner’s manual
24
EN
2.3 Adjust Device Angle
Adjusting ring
Locking screw
Step 1
Use cross screwdriver to loosen the locking screw.
Step 2
Adjust the device UDLR, set the monitoring direction according to the
application requirement.
Step 3
Use cross screwdriver to tighten the locking screw and twist the locking ring
firmly.
3. Network Configuration
You can initialize the device and modify IP address via WEB interface. Please
refer to the WEB Operation Manual in the disk for more details.
Step 3
Lay the fastening rubber ring onto the cable between waterproof fastening
cover and waterproof connection, and then stuff it into the main body of
waterproof connector.
Step 4
Cover the waterproof fastening cover on the main body of waterproof connector,
rotate the waterproof fastening cover clockwise to make it firmly locked with
main body of waterproof connector. So far, the installation has been completed.
Figure. 2-9