Dahua Technology DH-XVR58 S-4KL-I2-LP Series, User Manual

Page: 175 / 394

User’s Manual
165
Disk
Configure the settings for the HDD event.
Table 5-33 HDD event settings
Parameter Description
Event Type
In the Event Type list, select No Disk, Disk Error, or Low Space as the event
type.
Enable Enable or disable the HDD event detection function.
Alarm-out Port
Click Setting to display setting page.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the external
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and the
default value is 10 seconds.
Show Message
Select the Show Message checkbox to enable a pop-up message in your local
host PC.
Report Alarm
Select the Report Alarm checkbox to enable the system to upload the alarm
signal to the network (including alarm center) when an alarm event occurs.
Send Email
Select the Send Email checkbox to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main Menu >
NETWORK > Email.
Buzzer Select the checkbox to activate a buzzer noise at the Device.