21
6
Commissioning
Configuring Radar
6.1
Configure radar parameters.
Step 1
1) Log in to web interface of camera, and then select
Setup > ITC > Intelligent >
Radar
.
Radar
Figure 6-1
2) Select
Enable Radar
, and then you can configure the parameters.
Table 6-1 Radar parameter description
Parameter
Description
Enable Radar
Enable radar detection function.
COM SET
COM Port
COM1/2/3 corresponds to Lane1/2/3 respectively. COM port
depends on the number of lane (enable lane from
Setting >
ITC > Lane Property
).
Radar Type
Parameters of the selected radar need to be configured at the
right side of the interface.
Speed Limit Config
For Size disabled
You can configure the low/high speed limit.
For Size enabled
You can configure the low/high speed limit by vehicle size
(small vehicles (SV) and large vehicles (LV)).
ITARD-024
SA-I
Work Mode
The way of sending information captured by Radar.
Currently, the Camera supports only
Single
. Special program is
required if you want to send the information in continuous or
manual way.
Interval
The radar will recognize only one subject within the interval.
This function is available with the support of special program.
