12
4.2 Insert a Micro SD Card
1. Remove the rear panel from the back of the camera.
2. Insert the Micro SD card into the appropriate slot on the camera module.
3. Replace the rear panel.
Figure 4-3
4.3 Mounting the Camera to a Wall
1. Place the PFB300S Wall Mount against the wall and mark the location of the center hole and the
four perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
5. Wrap several turns of Teflon tape around the threads on the PFA110 Mount Adapter.
6. Screw the PFA110 Mount Adapter block into the internal thread of the wall mount bracket until
secure. Tighten the set screw on the wall mount to secure the mount adapter.
Figure 4-4
