Emergency Use
With both generators deactivated in flight, it is still possible to use battery power to
supply all airplane systems maintaining the SOURCE selector on BATT position.
In order to save battery power, it is possible to shed the charges that are not
essential for flight safety, for that set the ESS BUS TIE switch to EMER.
In this configuration, only ESS BUS 1, ESS BUS 2 and BATT BUS bars are
supplied.
NOTE
Supplying BUS 1, BUS 2, BUS 3 and BUS 4 bars is always possible, resetting
temporarily the ESS BUS TIE switch to NORM position.
Indicating
Electrical system indicating consists of voltage and ampere indicating – refer to
the Garmin Pilot's Guide for further details.
The following CAS messages may be displayed in the CAS window:
Table 7.9.3 - Electrical System Monitoring CAS Messages
CAS message
Description
BAT OFF
Battery is not connected to main bus bar
MAIN GEN
Starter generator is not connected to main bus bar
LOW VOLTAGE
Battery voltage is below the minimum value
GPU DOOR
Ground power receptacle access door is not closed
Protection - Safety
See
The electrical power system provides systems protection in case of:
-
overvoltage,
-
short-circuits.
Section 7
Description
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 02
Page 7.9.16
PIM - DO NOT USE FOR FLIGHT OPERATIONS