Daewoo W424, Instruction Manual, Page: 4 / 8

4
Water Inlet Wash Timer Wash Selector Spin Timer
Drain Selector
(Pump control)
Control Panel
OPERATING INSTRUCTIONS
Emptying
• Set the valve selector knob to “drain” and the wash timer to 3-5 minutes.
• The machine will now empty.
• Set the drain selector knob to “wash-rinse”.
• Switch off the electricity at the
power point.
Lint Filter
• Remove the filter frame by pulling it upward (Fig. 2-(1)).
• Turn the filter inside out and wash the lint off with water (Fig. 2-(2)).
• Insert the filter frame into the puls-ator hole as it was (Fig. 2-(3)).
Over flow Strainer
• Remove the strainer by pulling it forward (Fig. 3).
• Wash off the lint stuck in the stra-iner during overflowing.
• Re-install the strainer.
Drain Strainer
• Remove the drain strainer from the bottom of the tub using
a sharp tool such as
§^
driver (Fig. 4).
• Wash off the lint stuck in the strainer.
• Re-install the strainer.
Pulsator
• Should it be necessary to remove the pulsator, say to free an
obstruction, first remove the filter frame by pulling it upward,
and remove the screw securing the pulsator to the motor shaft
using
§] or §^ driver.
• Remove the pulsator by pulling it upward.
• Free the obstruction and refit the pulsator. Ensure that the screw is securely tightened.
• Insert the filter frame into the pulsator hole.
LINT ( 1)
( 2 )
( 3 )
Figure 2.
Figure 3.
Figure 4.