2
OPERATING INSTRUCTIONS
Preparing the Wash
●
Sort the clothes into groups-whites, colourfast, non-colourfast, delicates, lint free, lint producers,
etc., and wash according to the Laundry Guide below.
●
Clothes with worn patches or tears should first be mended. Empty out all
pockets and close all slide fasteners. Treat bad stains prior to washing.
Prior to Washing
●
Remove the plastic spin mat from the spin bowl.
●
Check that the wash timer knob is set to position “0” and that the drain selector is set to “wash ·
rinse”.
●
Also check that the lint filter is correctly positioned.
●
Ensure the drain hose is in its correct position (see lnstallation).
●
Insert the power cord plug into the power point and switch on.
To Wash
• Place the wash load and detergent in the wash tub. Refer to “Preparing the Wash” and “Points to
Remember”
• Set the drain selector to “wash · rinse”
• Turn the water tap on fill the tub of your washing machine to the level recommended in the
Laundry Guide.
• Set the selector switch to the position recommended in the Laundry Guide.
DRAIN HOSE SETTING
(1) Connect the drain hose to the drain outlet at the rear side of
your washer, and then fasten it tightly with the hose clamp.
(2) The other end of the drain hose setting toward the bath or
sinkhole.
(3) Install the drain hose about 85cm from the ground.
(In case drain pump model)
Hose Clamp
Drain Outlet
Drain hose
A
OPERATING INSTRUCTIONS
• Set the wash timer to the wash period recommended in the Laundry Guide.
Your machine will now wash for the period selected.
• When the wash period expires, set the drain selector to the drain position
to discharge the water.
Note: Before rinsing, the wash load may be transferred to the spin bowl to spin dry for 1
minute (approx.) to remove excess suds (see Spin Drying). On completion, transfer the
wash load to the wash tub for rinsing.
To Rinse in the Wash Tub
• Set the drain selector to the “wash · rinse” position.
• Turn the water tap on.
• When the rinse water becomes clear, turn off the water tap.
• Set the drain selector the drain position to discharge the water.
Note: The pump is turned on when the water reaches approx. 7cm above level H. It is then
turned off when the water returns to approx.
2cm below level H. It is operated automatically so that the water level maintains between
approx. 2cm below level H and approx. 7cm above level H.
Summary of Contents for W424
Page 8: ...W424...
