Daewoo T011, Service Manual, Page: 8 / 19

8
24 17 HPOS 60Hz HORIZONTAL PHASE
25 18 OSD OSD POSITION ADJUSTMENT
26 19 M-MODE ON M-MODE ON
27 1A EWCT 60HZ EW
Top-corner
28 1B WIDS 50HZ WIDS
29 1C VPOS 60Hz VERTICAL PHASE
30 1D HIT 60Hz VERTICAL AMPLITUDE
31 1E HPS 50Hz HORIZONTAL PHASE
32 1F VPS 50Hz VERTICAL PHASE
33 20 RCUT - R CUT adjust(decrease)
34 21 RCUT + R CUT adjust(increase)
35 22 GCUT - G CUT adjust(decrease)
36 23 GCUT + G CUT adjust(increase)
37 24 BCUT - B CUT adjust(decrease)
38 25 BCUT + B CUT adjust(increase)
39 26 HITS 50Hz VERTICAL AMPLITUDE
40 27 VLIN 60Hz VERTICAL-LINEARILTY
42 29 EWCB 60HZ EW bottom
-corner
44 2B BRTS Sub Bright
45 2C D-Mode ON/OFF D-Mode ON/OFF switch
46 2D VCEN Vertical Centering
48 2F POS UP Position Up
49 30 POS DOWN Position Down
50 31 Shopout Shop-out
51 32 S-PVOC LOGO ADDRESS
58 39 BUS OFF BUS OFF
60 3B VSC 60Hz VERTICAL-S CORRECTION
61 3C VLIS 50Hz VERTICAL-LINEARILTY
62 3D AGC RF-AGC
63 3E TV IC ADJUST White balance automatic adjustment
5.Service Controlled Function
The Service mode is entered by pressing the “D-MODE ON/OFF” key when the TV is in ON condition,”D” is displayed on
the screen.. Press the “POWER” key to exit Service mode.
Note:How to use user remote enter Service mode?
Press “MENU”
→ “
6
” → “
4
” → “
8
” → “
3
”
key
(1)White balance adjustment
The items within the White Balance mode can be accessed using “Item up” (
↑
)/ “Item down” (
↓
) keys and the selected
item value is modified using “Value+” (
→
)/ “Value-” (
←
) keys. The parameters controlled in the White Balance menu are:
a)Press the key to set the screen into a horizontal line
b)RCUT + : Red cut-off value increase
c)RCUT - : Red cut-off value decrease
d)GCUT +: Green cut-off value increase
e)GCUT -: Green cut-off value decrease
f)BCUT +: Green cut-off value increase
g)BCUT -: Green cut-off value decrease
h)Press the key again to return to the normal picture.
i)GDRV -: Green drive
j)
→
: value increase
k)
← :
value decrease
l)BDRV +: Blue drive
m)
→
: value increase
n)
:
value decrease
(2)Picture and AGC service adjustment
The items within the Picture mode can be accessed using “Item up” (
↑
)/ “Item down” (
↓
) keys and the selected item
value is modified using “Value+” (
→
)/ “Value-” (
←
) keys. The parameters controlled in the Picture menu are:
a) VCEN: 60Hz VERTICAL PHASE
b) HPOS: 60Hz HORIZONTAL PHASE
c) VPOS: 60Hz VERTICAL PHASE fine adjustment
D
043 VCEN
3A
00111010
D
009 GDRV
40
01000000