E-4
WARNING
Use of an earthed socket exclusively
For the appliance :
u
e
r
a
u
o
y
If
sing a socket with an earthed terminal, you do not require
a separate earthed connection.
Use of a non-earthed socket :
Connect the “earthed wire” to the steel plate and bury it at depth of
at least 25cm in the ground.
LEVELING
If the front of the appliances slightly higher than the rear, the door can be opened and closed more easily.
1. The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the arrow until the appliance is lever.
2. The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the arrow until the appliance is lever.
25cm
AD301-22(
영
).indd 3
2014-09-03
오전
11:10:18
INSTALLATION
INSTALLING THE FRIDGE / FREEZER
GENERAL INSTALLATION
1. Allow an adequate space and install the fridge /freezer on a firm, level floor.
If the appliance is not level, there may be unusual noises and poor cooling.
2. Clean the fridge / Freezer.
Wipe and clean the inside and outside of appliance with a damp cloth.
3. Plug the fridge / freezer into a wall socket used exclusively by this appliance.
This appliance must be properly earthed.
4. Place the food in the fridge / freezer.
r
It is ecommended that you wait for the appliance to cool for 3~4 hours before storing
food in it.
5. Keep 50mm of space between the refrigerator and the back wall.
f
u
s
n
I
ficient space causes the noise of vibration, weakening of refrigerating power and
the waste of electricity.
- Overall space required in use.
Refer to drawing and dimension as below.
6. The electrical plug must be accessible without moving the set.
7. For ambient temperature below 10°C, the perfect performance of our refrigerator can not be achieved.
8.
Leave the appliance to stand for 2-4hours before switching on to allow the gases to settle.
Wait 2-3 hours until the inside gets cold enough after the first power plug-in, then store foods inside(There can be some smell
on initial operation of the refrigerator after plugging in. The smell fades away as the refrigerator works and doors are opened
and closed.
The appliance can be noisy for first 7-10 days whilst setting.
The door seals may seem very tight for the first few days. This is normal and does not indicate a fault.
Select a location with level(or nearly level) and without direct exposure to sunlight and moisture.
