Daewoo Novus F3CBF, Manual

Page: 33 / 251

1-30 HOW TO HANDLE THE VEHICLE
(4) Side mirror defroster/Fuel preheating switch
Pressing this switch will actuate the defroster
installed in the side view to remove moisture or
frost.
The heating coil will actuate automatically for
15 minutes, and switch is not locked during op-
erating time and is "OFF" automatically in time.
Pressing the DDC engine truck's switch oper-
ates mirror heating coil and preheating of fuel
tank simultaneously, for can use for fuel unfreez-
MTA0271
MTS0190
MTA0713
ing in the winter.
(5) Cab tilt enable switch(The vehicle that the
hydraulic cab lock option system is applied.)
Before you tilt the cab, press this switch and
release cab lock at first. And then lift the cab by
pressing the switch located outside cab. While
this switch is pressed to "ON", cab tilt indicator
lamp on the instrument panel is turned on and
warning buzzer is sounded.
Caution
Before driving, push the cab-tilt switch again to
make "OFF" and check the indicator lamp "OFF".
(6) Diagnostic switch
1) DDC Engine
1. As another feature of the engine diagnostic
switch, if this switch is pressed with the start-
ing key positioned "ON" when engine prob-
lem occurs,
SEL
("Stop Engine"light:for ac- tive
codes) and
CEL
("Check Engine" light:for
inactive codes) will be flashing in the order of
most recent to least recent occurrence based
on engine hours so as to indicate engine prob-
lems by codes.
2. When the automatic stop engine sequence is
Caution
•
Active codes
These codes will be flashed on the "Stop
Engine" light(SEL). When code flashing is
initiated, it means severe engine problem.
In this case, take a proper measure for the
engine before continuing engine operation.
•
Inactive codes
These codes will be flashed on the "Check
Engine" light(CEL). When code flashing is
initiated, it means that your vehicle can be
operated but the engine has a problem.
Therefore, you must contact immediately the
nearest Daewoo Service Center for proper
service.
begun during travel(with the "Stop Engine" light
on), the operator must continue to press the
"Stop Engine Override" switch at intervals of
approximately 15 to 20 seconds until a safe
stop can be made. Each time this switch is
pressed, the engine is driven for additional 30
seconds with power limited.
Caution
If you operate the engine for extended period of time
by extending the engine driving using the engine di-
agnostic switch continuously, severe engine damage
may result. Therefore, you must stop your vehicle
somewhere near by.
https://www.truck-manuals.net/