12
8. To remove wind guide assembly.
1) Remove a screw for earthing.
2) Remove the noise filter from the wind guide.
3) Remove a screw which secure the wind guide assembly.
4) Draw forward the wind guide assembly.
5) Pull the fan from the motor shaft.
6) Remove two screws which secure the motor shaded pole.
7) Remove the motor shaded pole.
8) Reverse the above steps for reasembly.
9. To remove H.V. transformert.
1) Remove four screws holding the H.V.transformer.
2) Remove the H.V.transformer.
3) Reverse the above steps for reassembly.
DISASSEMBLY AND ASSEMBLY
Never install the magnetron without the metallic gasket plate which is packed with each magnetron to prevent microwave
leakage. Whenever repair work is carried out on magnetron, check the microwave leakage. It shall not exceed 4mW/cm
for a fully assembled oven with door normally closed.
NOTE
2
Summary of Contents for KOR-63350S
Page 20: ...19 WIRING DIAGRAM ...