2
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an electrical short circuit, earthing reduces
the risk of electric shock by providing an escape wire for the electric current. This appliance
is equipped with a cord having a earthing wire with a earthing plug. The plug must be
plugged into an outlet that is properly installed and earthed.
WARNING: Improper use of the earthing plug can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the earthing instructions are
not completely understood, or if doubt exists as to whether the appliance is
properly earthed. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade earthing plug, and a 3-slot receptacle that
will accept the plug on the appliance. The marked rating of the extension cord
should be equal to or greater than the electrical rating of the appliance.
INSTALLATION
Steady, flat location
This oven should be set on a steady, flat surface. This oven is designed for counter top
use only.
Leave space behind and side
All air vents should be kept a clearance. If all vents are covered during operation, the
oven may overheat and, eventually, oven failure.
Away from radio and TV sets
Poor television reception and radio interference may result if the oven is located close to
a TV, Radio antenna, feeder and so on.
Position the oven as far from them as possible.
Away from heating appliance and water taps
Keep the oven away from hot air, steam or splash when choosing a place to position it,
or the insulation might be adversely affected and breakdowns occur.
Power supply
• Check your local power source. This oven requires a current of approximately 15
amperes, 230V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on this oven. Using a higher voltage
may result in a fire or other accident causing oven damage. Using low voltage will
cause slow cooking. We are not responsible for damage resulting from use of this oven
with a voltage of ampere fuse other than those specified.
• If the supply cord is damaged. it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
Examine the oven after unpacking for any damage such as:
A misaligned door, Broken door, A dent in cavity. If any of the above are visible, DO
NOT INSTALL, and notify dealer immediately.
Do not operate the oven if it is colder than room termperature.
(This may occur during delivery in cold weather.) Allow the oven to become room
temperature before operating.
The minimum height of free space necessary above the top surface of the oven is
100mm.
1
2
3
4
5
6
7
8
