Daewoo KOM-9F2CKS, Service Manual, Page: 14 / 40

7. To remove high voltage capacitor.
1) Remove each two screws which secure four cover
exhausts.
2) Remove fourteen screws which secure rear plate
assembly.
3) Remove each screw which secures two grounding
ring terminal of the H.V. diode and two capacitor
holder.
4) Remove two H.V. diode from the capacitor holder.
5) Reverse the above steps for reassembly.
◆
High voltage circuit wiring
8. To remove magnetron.
1) Remove each four nuts which secure the
magnetrons.
2) Remove the two magnetrons.
3) Reverse the above steps for reassembly.
13
(1) To reduce gap located on part ‘A’
• Loosen screws on top of lock and then, close the door with
adjusting gap of front surface of oven.
• Tighten screw.
(2) To reduce gap located on part ‘B’
• Loosen screws on under of lock and then, close the door
with adjusting gap of front surface of oven.
• Tighten screw.
6. Method to reduce the gap between the door seal and the oven front surface.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm 2 .