8
1200W PTC Fan Heater
Model No. HEA1814
User Manual
IMPORTANT
–
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Setting the Temperature
•
Set the heater to the desired heat mode setting as above.
•
Press the
In
(5) and
Decrease -
buttons (6) until the desired
temperature is shown on the
Digital Temperature Display
(4) in
⁰
C.
•
Once the desired temperature is set, release the buttons and the display will
return to show the actual room temperature (in
⁰
C).
•
Press the
On/Off
button (7) to switch off the fan heater.
After switching off the heater, there will be a delay of several seconds in order
to cool the unit down before the unit finally switches off.
Oscillation Mode
Press the
Oscillate
On/Off
button (9) to enable the heater to rotate left and right
and disperse heat over a larger area.
Using the Timer
1.
Press and hold the
Mode
button (8) for 3 seconds
until the
Digital Temperature Display
(4) shows the
Timer display as shown right:
2.
Press the
In
(5) and
Decrease -
buttons (6) to
select the number of hours until the heater switches
off to a maximum of 9 hours.
The
Digital Temperature Display
(4) will alternate between showing the room
temperature and the timer counting down in hours.
Care and Use of your PTC Fan Heater
•
Always disconnect the heater from the mains power supply and allow to cool
before cleaning.
•
Clean outside of the heater with a clean damp cloth. Never clean with harsh or
abrasive cleaners.
•
Do not submerge any part of the heater in water or any other liquids.
•
DO NOT WRAP THE MAINS CABLE AROUND THE APPLIANCE.
Safety Cut
–
Out
WARNING
:
This appliance is fitted with a built in safety cut-out, if the cut-out
is activated the unit stops working, unplug the heater from the mains and check
that the air intake area is not blocked or covered.
Leave for an hour to cool and reset before plugging back into the mains.