Operating Instructions
Place the heater on a solid, level non-flammable surface.
Ensure that both heat Switches (1 & 2) are in the off position.
Insert the mains plug into the mains socket.
For the low heat setting (750w), press just Switch 1.
For the medium heat setting (1250w), press just Switch (2).
For the high heat setting (2000w), press both switches.
Rotate the thermostat control clockwise to increase the room temperature
and anticlockwise to decrease the room temperature as desired.
NB
the Indicators in the switches will illuminate on and off to indicate that
the set temperature is being maintained.
Return both the heat setting switches (1 & 2) to the
off position to switch off
the heater.
Hint on setting the correct temperature
Set the heater to the desired heat setting as above.
Rotate the Thermostat to the maximum position and allow the room to
warm up. Once the desired room temperature has been reached turn the
Thermostat anticlockwise until the heater just clicks off then turn it back up
clockwise very slightly. The Thermostat will now maintain the room
temperature, if necessary, further increasing or decreasing the thermostat
control may be required to ‘fine tune’ the ideal room temperature.
Return both the heat setting switches (1 & 2) to the
off position (as below)
to switch off the heater.
Care and Use of your Convector Heater
Always disconnect the convector heater from the mains power supply and
allow to cool before cleaning.
Clean outside of the convector heater with a clean damp cloth. Never clean
with harsh or abrasive cleaners.
Do not submerge any part of convector heater in water or any other liquids.
Summary of Contents for HEA1146
Page 7: ......