[Installation procedure]
1)
Join Connector to the tap water line
2)
Remove the pipe cap from the pipe.
3)
Then connect the pipe(from refrigerator) to the
filter connector which is already connected to filter
hose. Then fasten the snap ring on the hose.
4)
It will be ready to operate to your appliance.
Please check wheather it is correctly connected
like below.
[How to attach the filter box]
1)
Screw and fasten the filter holder to the left/right
side of the back of refrigerator.
✻✻
In case the holder is not fastened well,
remove the back paper of the tape on the
filter holder and attach it.
2)
Insert the filter box into the holder.
[After installation of water supply system]
1)
Plug in the refrigerator, press the [Dispenser]
button to choose water option on the control panel
and get the water on the glass to remove any air
(bubble) in the pipes and drain out the initial water.
Then, Switch to ice mode, press [Dispenser] to start
this function.
2)
Check for the water leaks again through the water
supply system (tubes, connectors and pipes)
Rearrange the tubes again and do not move the
refrigerator.
[Information concerning the water filter]
After use, the water system is subject to low
pressure. Proceed with caution when removing the
filter.
Flush the water system if the appliance has not
been in use for a long period of time, or if the
ice/water has an unpleasant taste or smell. To do
this, dispense water through the water dispenser
for several minutes.
If the unpleasant taste or smell remains, replace
the filter.
If pressure surges could occur in the water pipe, do
not install the water filter without a suitable surge
eliminator.
After installing a new filter:
Discard any ice produced in the first 24 hours after
switching on.
If no ice has been removed for a long period of
time,empty the ice box and discard any ice
produced over the next
