How to install the water line
You will require the following component and be able to
find it in water supply kit.
•
Water inlet hose x 1 ( 6m)
•
Water filter x 1
•
Snap ring x 2
•
Screws x 2
•
Wall plug x 2
•
Filter connector x 2
•
Filter holder x 2
•
Filter hose x 1 (4m)
●
The water pressure should be 1.44 ~8.27
Bar or more to run the automatic ice maker.
Checkup your tap water pressure; if a cup of
180cc is full within 10 seconds, the pressure is OK.
● When installing the water
hose, ensure they are not
close to any hot surfaces.
● The water fil
ter only filters water; it does not
eliminate any bacteria or microbes.
● If
your water pressure exceeds 8.27 bar a pressure
reducing valve must be installed.
●
Ensure connectors and hoses are securely attached
with no kinks.
The water hose should be connected to your cold water
supply.
[Get ready to install the water filter]
1)
Remove the cap from both side of the water filer.
2)
Connect the hose to the filter as the image shows.
There are two side of the filter and there will be the
arrow in the label onthe water filter in order to clarify
the side.
*‘side A’ should be linked to the pipe in
refrigerator. ‘side B’ should be connected to the
water tap.
<side A>
<side B>
3)
Once all done, it should be like the below.
