Operation Section
-69-
Fuel Selector Switch
(G424E/G430E Dual Fuel Only)
1.
LPG - This position supplies electrical
power to the LP fuelock solenoid, when
the ignition switch is in the ON or the
START position.
With the LP-Gas fuel tank valve open, LP-Gas can
then flow the tank through the converter to the
carburetor.
2.
OFF – This position shuts off all fuel
supply to the carburetor/injector.
3.
GAS - This position supplies electrical
power to gasoline fuel pump and injector
This will allow gasoline fuel to flow from
the tank through the fuel filter and fuel
pump to the injector.
Lift Truck Controls
Direction Control Lever
1.
Forward - Push the lever forward for
FORWARD direction travel.
2.
Neutral - Move the lever to center
position for NEUTRAL.
3.
Reverse - Pull the lever back for
REVERSE direction travel.
Plate for Function of Pedals (If Equipped)
It shows the function of each pedal i.e. inching
(clutch), brake and accelerator.
Transmission Inching Control
Pedal
Inching Control Pedal - Pushing down on
the inching pedal, modulates the hydraulic
pressure to the clutch packs, permitting disc
slippage.
Further pushing on the pedal completely relieves
clutch pack pressure and applies the service
brakes to stop and hold the lift truck.
NOTE:
The purpose of the inching control pedal is
to provide precise inching control at slow
travel speed, with high engine rpm. This is
used for fast hydraulic lift during load
approach, pickup or positioning.