Maintenance Section
-168-
5.
Remove and discard oil filter element.
6.
Wipe sealing surface of oil filter element
mounting base. Make sure the entire old gasket
is removed.
7.
Before installing a new filter element, apply a
small amount of clean engine oil to the filter
element gasket.
8.
Install the new filter element. When the gasket
contacts the base, tighten it 3/4 of a turn more.
Do not over-tighten.
9.
Raise the lift truck, remove the blocking and
lower the lift truck.
10.
Fill the crankcase. See “Refill Capacities”.
11.
Start the engine and allow the oil to fill the filter
and passages.
12.
Check for oil leaks.
13.
Stop the engine and measure the oil level.
Maintain the oil level to the FULL mark on the
dip stick.
14.
Close hood and seat assembly
PCV Valve System - Inspect,
Clean
G424 Gasoline, LP-Gas and Dual Fuel
Engines
G430 LP-Gas Engines
1.
Loosen the hose clamps and remove the PCV
valve.
2.
Shake the PCV valve. If it rattles, reinstall it. If it
does not rattle, replace it.
3.
Tighten the hose clamps