6
Be careful not to confuse hot water inlet (pink color) and cold water inlet (blue color),
if your washer is provided with dual water inlets.
Also if you have only one water tap, connect the inlet hose with cold water inlet (blue color).
* In case that your washer is not provided with collar compartment, procedure
#
and
%
is not
necessary.
For normal tap
!
Pull down the collar of the
inlet hose to separate it
from the hose adapter.
@
Loosen the four screws
properly in fitting into
water tap.
#
Fit the hose adapter into the water
tap and tighten the four screws
evenly while pushing up the
adapter so that the rubber packing
can stick to the water tap tightly.
$
Remove the tape, and
screw connector B into
connector A tightly.
%
Connect the inlet hose to
the hose adapter, pulling
down the collar of hose
end.
^
Connect the opposite end
of the hose to water inlet
of your washer tightly.
• Please check the rubber
packing is inside the
hose end.
TAPE
Connector B
Connector A
;
;
;
WATER CONNECTION
For Thread-Fitting Type
!
Connect the inlet hose to the thread of
water tap or water pipe by tightening.
@
For the opposite end, connect it to water
inlet as the above procedure
^
.
Connector
Connector
Rubber
Packing
Hose
Turn on the water completely to check for any leakage. If any leakage, turn off the water, try
again as the above procedures.
For the special tap, call a qualified plumber for the installation.
Leak Test
