3
Read all instructions before using your washer
Save these instructions
Your safety is important to us.
To reduce the risk of fire, electrical shock, or injury when using your washer adhere to
the following basic precautions.
Understanding your responsibilities
•
Flammable fluids (dry-cleaning solvents,
kerosene, gasoline, etc.) should not be
used or stored in or near your washer.
Do not add flammable fluids to your wash
water. These substances give off vapours
that can create a fire hazard or explosion.
•
Have only a qualified person install, repair,
or replace parts on washer.
•
Maintain washer properly.
•
Protect washer from the weather and keep
it where the temperature will not fall below
freezing.
•
Do not install the washer at a place of
extremely high humidity. It could cause an
electric shock or a short circuit.
•
Ground washer properly.
•
Connect washer to the correct outlet, electrical
supply, water supply, and drain supply.
•
Do not wash fiberglass materials.
Small particles can stick to fabrics washed in following loads and cause skin irritation.
•
After starting a cycle, do not reach into the
spin basket until all motion stops.
•
Do not tamper with the controls.
•
The appliance is not intended for use by
young children or infirm persons without
supervision.
•
Do not use chlorine bleach and ammonia or acid (such as vinegar or rust remover) in the
same wash. Hazardous fumes can form.
•
Young children should be supervised to ensure
that they do not play with the appliance.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
•
Do not use hot water if standard temperature is over 50
˚
C (122
˚
F).
It could cause a deformation of plastic parts.
•
Do not spray water on the control panel and back cover of the washer.
It could cause fire or an electric shock.
•
In case of the dual valve model, if you connect only cold water inlet valve, while water temperature
is selected as hot or warm, there can be water leakage from unconnected water inlet valve.
•
Unplug power supply cord before attempting to service your washer.
•
If the appliance is supplied from a cord extension
set or electrical portable outlet device it should be
positioned so it is not subjected to splashing or
ingress of moisture.
Please ...
WASHER SAFETY
