Daewoo DWD-VF80M1, Service Manual

Page: 4 / 24

2. INSTALLATION
3 INSTALLATION
■
Removing transit bolts
1. Before operating the washer, remove the four transit bolts which are located at the rear of the washer.
• If the bolts are not removed, it may cause heavy vibration, noise and malfunction.
2. Unscrew the 4 bolts with the suitable spanner. Keep the 4 bolts and spanner for future use.
• Whenever the appliance is transported, the transit bolts must be refitted.
3. The plastic parts located inside the washer will fall down under the machine.
• If all of them have not fallen down, open the washer door and move the drum until all plastic parts fall
down.
• Lift the washer slightly and pick up the plastic parts.
• To the holes where the transit bolts have been removed, insert the plastic cap holders supplied.
■
Location of washer
• Check location where the washer will be installed. Make sure you have everything necessary for correct
installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any time.
• Install washer on an even, horizonal, non-slippery and tough floor. If the
washer is installed on an unsuitable floor, it could make considerable
noise, vibrate severely and cause a malfunction. If the washer is not
level, adjust leg up or down for horizontal installation.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
• Leave space around the washer upon installation (right and left: 2cm,
rear: 10cm)
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 3mm.
Laundry
Tub
Washer
approx.
2cm
Drain Hose