EN -28-
EN -29-
EN -28-
•
Your washing machine is set to 220-240V and
50Hz.
•
The mains cord of your washing machine is
equipped with a
specific
earthed plug. This plug
should always be inserted to a earthed socket of
10 amps.
•
The current value of the fuse should be 10 amps.
Fuse current value of the power line connected to this plug
should also be 10 amperes.
•
If you don’t have such a receptacle and fuse
confirming
with this, please have it done by a
qualified
electrician.
•
We do not take the responsibility of the damages that oc-
cur due to ungrounded usage.
NOTE: Operating your machine under low
voltage will cause the life cycle of your
machine to be reduced and its perfor-
mance to be restricted.
CHAPTER -3: INSTALLATION OF THE MACHINE
(ELECTRICAL CONNECTION)
EN -29-
•
Your machine may have either a single inlet
(cold) or double water inlets (cold/hot) based on its
specifications.
White-capped hose should be connected to cold
water inlet and red-capped hose to hot water inlet
(applicable for machines with double water
inlets).
•
To eliminate water leakages in points of contact,
1 or 2 nuts are provided in the hose package (ap-
plicable for machines with double water
inlets).
Fit these nuts to the ends of new water inlet hoses
on the side of
faucet.
•
Mount new water inlet hoses to a ¾
˝,
threaded
faucet.
•
Connect the white-elbow end of the water inlet
hoses to the
white-filtered
water inlet valve on the
rear side of the machine and the red-elbow end to
red-filtered
one (applicable for machines with dou-
ble water
inlets).
Tighten plastic parts of the junctions using your
hand.
In uncertain conditions, have the connection works
be done by a
qualified
plumber
.
•
Flow of water with pressure of 0,1-1 Mpa will
allow your machine to operate more
efficientl
y
.)
(0,1 Mpa pressure means that more than 8 litres
of water will
flow
through a fully-tapped faucet per
one
minute.)
•
Ensure that points of contact do not leak by tap-
ping the faucet completely after carrying making
the
connections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10 mm
UK(���)(6 7 8kg)(�).indd 29
2015-11-26 �� 10:44:44
