Daewoo DWD-E113R, Service Manual

Page: 42 / 57

39
* Replaceing method of Heater and Temp. Sensor
1. Disassemble Connector
3. Replace heater & sensor
2. Disassemble EARTH and NUT for fixing heater
4. Assemble in the reverse order. Be sure to assemble in the
order : Nut for heater-Nut for EARTH.
* ERROR MODE
1. "H1" : Thermistor Dry OPEN/SHORT
2. "H2" : Thermister Wash OPEN/SHORT
3. "H3" : Dry Overheating(Sensing Temp. is over 125°C)
4. "H4" : Wash Overheating(Sensing Temp. is over 95°C)
5. "H5" : Wash Overheating
(In Wool, Lingerie courses sensing temp. is over 45°C)
6. "H6" : Abnormal condition of Heater Wash
(when the temp. increase at 10 minutes after heater operation is under 10°C)
7. "H7" : Abnormal condition of Heater Dry(when the temp. increase at 10 minutes after heater operation is under 10°C)
8. "H8" : Heater Wash Overheating
(when the temp. increase within 30sec after heater operation is over 5°C without water)
9. "E3" : FAN MOTOR Broken(no signal from HALL IC)
I
C
D
F
E
H
B
A
G
Division Parts Name
A DUCT COVER
B FAN MOTOR
C HEATER DRY
D DUCT B LOWER
E THERMOSTAT(Bimetal)
F THERMISTOR (Temperature Sensor)
G DUCT B UPPER
H FAN AS
I FUSE TEMPERATURE