8
TROUBLE SHOOTING
PROBLEM
CHECK POINT
Is the Power properly
connected?
Is the Motor hot?
(In case there is
Thermal Protector)
Is the Wiring good?
(Refer to the Wiring
Diagram)
Is the contact of Wash
Timer good?
Is there a whirring
sound from the
Wash Motor when
turned on?
Is the Condenser
properly connected?
Motor does not start due to
opening the Condenser circuit.
Power has been cut off by the
Thermal Protector
Improper wiring.
Defective Wash Timer.
Defective Wash Motor.
CAUSE
SOLUTION
Reconnect the Power
Cord.
Reconnect the
Condenser.
Power restored when
Motor cools
Reconnect the wiring.
Replace Wash Timer.
Replace Wash Motor.
NO
NO
NO
NO
NO
YES
Are the Pulsator and
Motor Pulley securely
assembled?
Defect of mechanical
assembly.
Tighten the screws fixed
on the Pulley.
YES
NO
Are there impurities
between the Pulsator
and Tub.
Revolution obstructed by
impurities.
Remove impurities after
disassembling pulsator.
NO
YES
Does the pulsator shaft
rotate propely when the
pulsator has been disas-
sembled?
Worn out the Serration
within the pulsator.
Replace pulsator.
YES
Does the V-Belt slip?
Worn out V-Belt.
Replace V-Belt
NO
YES
YES
NO
Is the wash load
appropriate?
Reload with proper wash
load.
NO
YES
YES
YES
YES
Pull out the power plug prior repair and make sure that the Washing machine has been properly grounded.
NOTES
C o n c e r n i n g W a s h
PULSATOR
DOSE NOT
ROTATE.
PULSATOR
DOES NOT
ROTATE
SMOOTHLY.
Defective Case Shaft As.
Replace Case Shaft As..
NO
4. TROUBLE SHOOTING GUIDE
