background image

POINTS TO REMEMBER

Avoid using excessive amounts of bleach, soap powder or detergent, Use the amount rec-
ommended by the respective manufactures.
If the machine is installed in areas subject to freezing temperatures, ensure that it is com -
pletely drained after use.

  To reset to the OFF position ("0"), turn anticlockwise.

When washing delicates e.g., silks, fine nylons, lace, etc., it is advisable to place them in a
mesh bag to prevent the possibility of damage.
Do not wash lint attracting fabrics with lint producers, e.g., black socks or dark coloured

Put the safety cover on the wet laundry before spinning to secure safety.

jumpers with white fluffy towels, napkins, etc.

  Avoid placing a wet wash load on the control panel.

BEFORE YOU CALL FOR SERVICE

There may be times when you suspect your washing machine requires maintenance.
Before calling for a service engineer, please check the 
following points, to save unnecessary cost. You may be pleasantly surprised that an
apparent malfunction can be easily rectified by following the chart below.

If your washing machine will not start, check whether:

  The house circuit breaker is tripped or a fuse is blown.

The plug is firmly connected to the power point or the power point is not switched on.(Check
with a small table lamp or toaster, etc.)

  Something is preventing the agitator from rotating.
  The wash timer is set.
  The drain selector switch is set to "wash-rinse".

If the spin dryer will not operate, check whether:

  The inner and outer spin bowl-lids are closed.
  The spin dry timer is set.

If there is excessive noise, check whether:

  Something is touching the agitator as it rotates.
  The machine is placed on a level surface.

 The wash load in the spin bowl is excessively unbalanced during the spin cycle.

  An article is lodged between the spin bowl and tub.

MAINTENANCE AFTER USE

Wash Day Maintenance At the end of each wash day:

  Switch off the electricity at the power point.
  Check that both timers are set to the OFF position ("0").

Wipe off spillage from wash powder, etc., and generally wipe over the cabinet with a clean
damp cloth.

  Remove the hose from water tap.

* Design and specifications subject to change without notice.

5

SPECIFICATIONS

Dimension

749mm X 464mm X 870mm (W X D X H)

Machine Weight

32 kg

Power Source

120V/60Hz

High

50 L

Water Level

Medium

43 L

Low

36 L

Power Consumption

480W

 DW-444PA  00.4.26 11:8 AM  ˘

`

5

Summary of Contents for DW-444PA







Reviews: