INSTALLATION
Electrical Connection
In case of 3-core cord: The power plug must be connected to an earthed 3-pin power point
within reach of the power cord.
In case of 2 conductor power cord: Connect the grounding wire to a water faucet etc. Make sure
that the power cord is unplugged during ground work.
Connection of Hoses
Attach the drain hose to the drain outlet at the left side of
the under base and secure with the clamp provided.
Hang the "U" Shaped outlet of the drain hose on the
edge of a sink.
Place of installation
Choose a place on a horizontal solid floor. If the machine is installed on an unstable floor, heavy
vibration will result during spin.
Attach the water inlet hose to the water inlet located at
the left-hand side of the control panel. Press fit the other
end of the hose to either a hot or cold water tap as
required (Fig. 1).
WATER INLET PORT
1
PARTS IDENTIFICATION
Figure 1.
Drain Hose Assembly (PUMP)
Safety Cover
Accessories
Lint Filter
Water Inlet Port
Agitator (with Lint-filter)
Wash Tub
Wash-Tub Lid
Wash Action Selector
Drain Strainer
Overflow Strainer
Spin Timer Switch (5 min. timer)
Power Cord
Spin Tub
Power Cord Rack
Panel Front
Drain Hose Assembly
(NON-PUMP)
Inner Lid of Spin-dry Tub
Prevent your hands, etc.,
from touching the spin-dry
basket in rotation
Spin-tub Lid
When this lid is opened, the spin dryer
immediatelystops operating
Drain Selector (Pump Control Switch)
Rub-Wash Section
Wash Timer Switch
(15 min. timer)
DW-444PA 00.4.26 11:8 AM
