Daewoo DTM-2930MP, Service Manual, Page: 11 / 66

ALIGNMENT INSTRUCTIONS
4.5.2 OPTION 2 BITS
- Remote control(Bit 7)
This is not intended to be changed by use of the FACTORY remote control.
- NEC/Daewoo Remocon(Bit 6)
User remote control configuration, the choise being between the following;
- NEC rem ocon(T)
- Daewoo R-46G22(‘0’)
The R-30SVC7 “FACTORY” remote control will never be affected by this setting.
- AV out option(Bit 5)
This allow you to select the desired signal at output pin 46. When set to 1 the output is monitor
out otherwise the output is the CVBS signal demodulated from the tuner IF. Sound output is
also swiched(#37 and #38).
- Local keyboard option (Bit 3 & 2)
11
10 01 00
0 mV ~ 220 mV Not used Menu Menu
220 mV ~ 620 mV (TV/AV) Menu TV/AV Prog. Up
620 mV ~ 1.06 V Vol. Up
Vol. Dwn Prog. Dwn Not used
1.06 V - 1.48 V Vol. Dwn Vol. Up Vol. Up
1.48 V - 1.79 V Prog.Up Prog. Dwn Vol. Dwn
1.79 V - 2 . 0 7 V Prog. Dwn Prog. Up TV/AV
- Digital eye ON/OFF(Bit 1)
Enables/disables the digital eye function.
When enabled and selected, the microcontroller measures DC level on IC pin 15, and adjusts
picture setting according to the table below.
Brightness Contast
Colour
Sharpness
0 mV - 450 mV
18 30 26
27
450 mV - 900 mV 28 46 28 29
900 mV - 1.35 V 30 50 29 30
1.35 V - 1.80 V 32 55 30 31
1.80 V - 2 . 2 5 V 34 60 31 32
2.25 V - 2.70 V
36 63
32
33
- PARS Logo ON/OFF(Bit 0)
Enables/disables the display of PARS logo at power on.
4.5.3 OPTION 3 BITS
- Curtain function at power ON(Bit 7)
Enables/disables the curtain function at power ON. The frequency and volume of associated
beep sound is controlled by NVM data.
-10-