Daewoo DLT-26C2, DLT-26C3, DLT-32C1,, Service Manual

Page: 24 / 108

-24-
5. SERVICE MODE
5-1.Entering SERVICE MODE
Using the Service Remote controller, you can enter service mode directly.
5-1-1.Adjustment REMOCON and EEPROM Initial DATA
A.The adjustment Specification use the SERVICE REMOCON R-34SVC
(S/N:48B3034SVC)
B.Adjustment DATA
Key
S1
Menu
Heat Run Mode Full White
2007. 05. 11
0-50-100-L-R
Black-W-R-G-B
to enter into Heat Run Mode
Sub Menu
Default Value
Description
S2
Gumi Ch Map Write to set Gumi factory channels directly
S3
Volume Test to set sound(display in sequence)
S4
HDMI EDID WRITE to write HDMI EDID data directly from main chip
S5
Test Pattem to display Test Pattem in sequence
Bri_Min-Cen-Max
S6 Picture Test
S7 DEMPOL CH Map Write
to test picture(displays in sequence)
Con_Min-Cen-Max to test picture(displays in sequence)
Col_Min-Cen-Max
to test picture(displays in sequence)
to test picture(displays in sequence)
S8 Write Balance
S9
S10
S11
S12
Sound Prescale
Sound Delay
Dimming Control
IFAGC Contronl
Frequency
Gamma
DLC
Memory Recall
Oper Mode
Don’t use
Version information
Factory Mode
Offset R
32
input Source Display to display present input source mode
to display offset and gain value at mode above
to display the matched real value of the offset
and gain
Offset G 32
Offset B 32
Gain R 32
Gain G 32
Gain B
32
Read Value 32
to display sound prescale value at each mode
to active or inactive sound delay mode
Speaker_SIF 32
Speaker_AV3 DVB
Speaker_AV2
Speaker_HDMI
37
43
47
Speaker_AV1 PC COM
Scartout_SIF
55
88
Scartout_EXCEPTSIF 88
Delay Enable
to assign delay value
Delay value
OFF
0
254
18
to apply the changed value about sound delay
to control the dimming value of the panel
to adjust IF AGC value about signal except
SECAM L/L’
to adjust IF AGC value about SECAM L/L’
to display the frequency of the present signal
to active or inactive gamma function
to active or inactive DLC function
to reset EEPROM
Normal Mode-Debug Mode-Data Writing Mode
to display the date of the firm ware
to initialize TV and make TV standby mode
¡
White Balance items(S8) are not initialized
Apply
IFAGC NORMAL
16
000 MHz
OFF
OFF
NOR-DEB-DW
IFAGC L or L’