Daewoo DLA-32C7LAB, Service Manual

Page: 62 / 73

H W
A A
N L
G L
E
R
U
N
I
T
HANGER AS UNIT
4
Because the weight of the product assembly is heavy,
it requires special care for the location to install the product.
You must check the wall material before the installation.
When installing the product on the concrete wall
You must install the product using the included anchor as the
component.
The supplied anchors and screws should be used only when the
thickness of the finish materials is less than 10 mm.
When installing the product on the wooden wall
Because the wall must be able to support the weight of the product
adequately, it requires reinforced supper separately.
During the installation, make sure all people besides
the work are not close by.
The installation work must be done by more than 2
people.
Fixate the hanger to the wall where it is flat and can
be closely aligned to the wall.
When mounting to the hanger, place a sheet on the
floor for the work.
The tightness of the product must be checked after
the installation.
You must follow the details during installation or transportation.
It can cause an injury.
If you disassemble the stand with the stand in upright position,
the set can fall to cause injury or damage to the product.
If attached on an unstable wall, the unit can fall and break
Because the product is heavy, it can cause injury
or damage to the product when it falls.
Caution
Caution
Caution
Caution
Caution
Caution
Caution
1. When installing the wall mount, you must use the components and parts provided with the product.
2. Before installing the wall mount, you must connect the connecting wire of the applicable device to the
product terminal.
3. The company is not responsible for the product damage or injury that occurs when the consumer uses a wall
mount not specified or installs the wall mount arbitrarily by himself/herself.
4. Do not let children play under the product.
5. When turning the angle or rotating the product, be careful not the hit the back of the product to the wall. (You
can prevent the product from being damaged by the wall by attaching pieces of sponge at the 4 corners.)