10
Leveling the ice maker
It is important for the ice maker to be leveled in order
to work properly. Otherwise water will not flow
properly through the evaporator (ice mold). The
ice production will be less than normal, and may
be noisy. The unit can be raised or lowered by rotating
the plastic sheaths around each of the four rolling
casters on the bottom of the machine. If you
find that the surface is not level, rotate the casters
until the ice maker becomes level. You may need
to make several adjustments to level it. We
recommend using a carpenter’s level to check
the machine.
1.
Place a carpenter’s level on top of the unit to see if the ice maker is level from front to
back and side to side .
2.
Adjust the height of the
casters as follows:
Turn the leveling casters to the right to lower that side of the ice maker.
Turn the leveling casters to the left to raise that side of the ice maker.
You will find that the casters make it easy for one person to move the machine. This is
useful for cleaning and sanitizing the surface on which the ice maker is installed because it
allows you to move the unit and have easy access to the surface to be cleaned.
IMPORTANT: When the ice maker is ready to be installed in a cabinet or directly on the
floor, you must adjust the feet to level the ice maker and lock the rollers. If the floor is
level, just revolve the two front feet to touch the floor.
Reversing the door swing
Tools needed:
flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.
To remove door from hinges:
1.
Remove the top hinge cover.
2.
Using a Phillips screwdriver, remove the screws, then remove the top hinge mat and
top hinge. Keep the parts together and set them aside.
3.
Lift the door off of the bottom hinge and set the door aside.
To replace door on hinges:
1.
Using a
flathead screwdriver
, remove the plug buttons from the screw holes opposite the
door hinges, top and bottom. Set aside.
2.
Remove the front louver. Set aside.
3.
Remove the bottom hinge and place it on the opposite side at the bottom of the door.
down
up
