When the wo rking cycle has fi nished, the buzzer of the dishwasher will soun d for 8 seconds, then stop. Turn off
t he appliance using the P owe r switch button, shut off the water supply and open the doo r of the dishwasher.
Wait for a few minutes bef ore unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while th ey
are still hot and more susceptible to break age. The y will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
Power
1.Switch off the dishwasher by pressing the
button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
If you open the door
, the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
dur ing a wash cycle
Premise:
1
A cycle that is underway can on ly be modified if it has only been running for a short time. Otherwise, the
detergent may have already be en released, a nd the appliance may have already drained the wash water.
If this is the case , the detergent dispenser mu st be refilled (see the section entitled " Loading the
Detergent " ).
2
Press the Start/Pause button , the machine will be in standby state, press the program button more than
3s then you can change the program to the de sired cycle setting (see the section entitled " Starting a wash
cycle. . ." ).
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working,you can open the door
completely.
2
3
Open the door a little to stop the washing.
1
4
5
6
Press the Start/Pause button
Press the
button, the dishwasher will run
after 10 seconds.
Start/Pause
When you press the Start/Pause button to pause during washing, the running indicator will
stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.
Wash th e arms in soapy and warm water and u se a soft brush to
clean the jets. Replace th em after rinsing them thoroughly.
When following this procedure from step1 to step 3, the filter system will be removed;
when following it from Step 3 to Step 1, the filter system will be installed.
It is dangero us to open the do or when was hing, because the hot water may s cald you.
If your model has broken remember function, the machine will go on to finish the selected
program
.
after the power cut
