2
EN
MODEL
DAST01C
285 mm
2
405 mm
7 - 1/16 X 6 - 1/2”
CAPACITY
(TON)
MIN.
HEIGHT
MAX.
HEIGHT
BASE
DIMENSIONS
1. SPECIFICATIONS
2. IMPORTANT SAFETY INFORMATION
Read these safety warnings before operation.
WARNING!
Failure to read these warnings may result in personal injury damage
WARNING!
Do not overload Jack stands beyond rated capacity. Overloading can cause damage to or failure of
the Jack stands.
POSITION LOAD ON CENTER OF SADDLE ONLY ALWAYS USING STANDS IN PAIRS ON HARD,
LEVEL SURFACE CAPABLE OF SUSTAINING THE LOAD. USING OF STANDS ON OTHER THAN
HARD LEVEL SURFACES CAN RESULT IN STANDS' INSTABILITY AND POSSIBLE LOSS OF LOAD
3. OPERATION
1. Refer to your vehicle owne
r
s manual for proper Jacking procedure.
2. Position stands under vehicle at points specified by vehicle manufacture as proper load support
points.
3. Load just 8 tands: Hold control lever up tile lifting saddle shafl to desired height.
Push control lever down to lock pawl lnto teeth located in center column.
MAKE SURE PAWL IS FULLY ENGAGED INTO TEETH.
4. Carefully lower load onto stands.
4. MAINTENANCE AND INSPECTION
1. Visual inspection shall be made before use of the stands, checking cracks. Cracked welds and
missing and/or dama parts. And stand that appears to be damaged In anyway shall be removed
from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED THE MISUSE OF EQUIPMENT OF THIS
TYPE, NO REPLACEMENT SHALL BE MADE TO THE PRODUCT.
