Vehicle Systems
Disassembly & Assembly
Brake Hydraulic Booster
Remove And Install Brake Hydraulic
Booster
1.
Remove the floor plate over the brake hydraulic
booster.
2.
Disconnect pressure line (3).
3.
Disconnect return line (4) and supplement line (1).
4.
Disconnect brake line (5).
5.
Remove pin (6) and bolts (7).
6.
Remove hydraulic booster (2).
NOTE :
The following steps are for installation of the
brake master cylinder.
NOTE :
Installation is reverse order of removal.
7.
Remove the air (bleed the brake lines). See the
topic Brake System Air Removal in Testing And
Adjusting.
8.
Install the floor plate over the brake master
cylinder.
Tie Rods
Remove And Install Tie Rods
Start By :
a.
Remove steer wheels.
NOTE :
The procedure to remove and install the tie
rod is the same for each steer wheel.
1.
Support the steer axle with a floor jack (A).
Position the wheel to gain access to the tie rods.
2.
Remove two pin retaining bolts (2). Remove pins (1).
3.
Remove tie rod (4) and dust seals (3).
4.
Use tooling (B) to remove bearings (5) from the tie rod.
5.
Use tooling (B) to install new bearings (5) in the tie rod.
6.
Install the tie rod in the reverse order of removal.
Tools Needed
A B
Floor Jack
1
Drive Set
2
21
IACD211P
3
2
7
6
1
5
4
IACD212P
1
3
4
2
IACD213P
5
