CB650M-BX Mother Board
2 - 5
3. Installing and Removing DIMMs
To install the DIMMs, locate the memory banks on the motherboard and
perform the following steps :
1. Hold the DIMM so that notched edge is aligned with the notch on the DIMM
s o c k e t ( F i g u re 2-1).
2. Insert the DIMM at a 90 degree angle.
3 . Gently push the DIMM straight down until it locks into place(past the re l e a s e
t a b s ) .
Figure 2-1. Installing a 168-pin DIMM
To remove DIMMs, follow the steps below:
1. With both thumbs (or fingers), press the release tabs away from the socket.
2. With the DIMM free from the release tabs, lift the memory module up and
place in the anti-static bag or package.
The C B 6 5 0 M - B X is designed to support single Pentium II/III processor or
C e l e ro n p ro c e s s o r. The Pentium II/III processor comes installed in a
SECC(Single Edge Contact Cartridge) or SECC2 that connects into “Slot 1” on
the motherboard. Add the Celeron processor comes installed in a Single Edge
P rocessor Package (SEPP) that connects into “Slot 1” on the motherboard .
Installing the Processor
CB650M-BX(1,2¿Â) 00.5.12 2:8 PM
∆
‰¿Ã¡ˆ2-5
