Daewoo AKD-0275 Series, Service Manual

Page: 44 / 46

HOW TO INSTALL
- 42 -
Detaching the front panel
1. Press the release knob to open up panel.
2. Holding the middle upper side of the panel, pull it straight out towards the arrow
direction.(See the figure)
3. The red lamp blinks to tell you that the front panel has been detached.(It could be
stolen)
4. Do not press the panel hard against the unit. It can easily be attached by pressing it
lightly. And, beware not to drop it.
5. Keep the front panel in the supplied protection case.
Attaching the front panel
1. Holding the panel at its top and bottom edges.
2. Attach one side of the panel lightly first, then push the other side of the panel into the
unit.
Keep in mind :
-
If it works malfunction, take the panel off and put it back again.
-
Do not touch the contact pins on the rear of the front panel, this can cause contact errors.
If the contacts are not clean, clean contacts with a cotton swab dipped in alcohol.
-
Do not expose the front panel to direct heat or cold.
-
Be careful not to splash juice or other soft drinks into the car audio.
-
Do not apply too much force. Otherwise, the panel may be damaged.
-
Never take the front panel apart.