27
5-4. E1 Error - Error in Water Level Detection
1) Conditions
1
The water level is below the reset level or above the overflow level in the line test mode.
2) The drainage synchronous motor continues to work until the water level drops to the reset level.
3) If the Power button is turned off and on, the error display disappears.
5-5. E2 Errors - Overflow Error
1) Conditions for E2
1
The water supply valve is running when the washer is turned off and the operation is suspended so that the
water level reaches the overflow level.
2
If the errors are detected two times or more during operation, the '2' error appears on the display panel. The
operation is suspended, but water continues to be drained.
3
The drainage synchronous motor continues to work until the water level drops to the reset level.
4
If the water is not drained until the water level drops to the reset level, the 'E2' error appears on the display
panel.
2) The drainage synchronous motor continues to work until the water level drops to the reset level.
3) The "E2" error flickers on the display panel.
4) If the Power button is turned off and on, the error display disappears.
5-6. E9 Error - Error in water level sensor
1) Conditions
1
The water level sensor transmits a frequency of 19KHz or lower or 28KHz or higher due to malfunctions.
2) The "E9" error flickers on the display panel.
3) The error warning is sounded for 10 seconds every 10 minutes.
4) If the water level sensor transmits a frequency is 21KHz or lower or 29KHz or higher, the error display
disappears.
MINI 2.0_COMBO,WASH_영문_SM.indd 27
2017. 8. 25. 오전 11:16