5
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord
having a earthing wire with a earthing plug. The plug
must be plugged into an outlet that is properly installed
and earthed.
WARNING : Improper use of the earthing plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the earthing instructions are
not completely understood, or if doubt exists as to
whether the appliance is properly earthed. If it is
necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade earthing plug, and a
3-slot receptacle that will accept the plug on the
appliance. The marked rating of the extension cord
should be equal to or greater than the electrical rating of
the appliance.
IMPORTANT
The wires in this mains lead fitted to this appliance are
colored in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug, proceed
as follows : the wire which is colored green-and-yellow
must be connected to the terminal in the plug which is
marked with the letter ‘E’ or by the earth symbol or
green-and-yellow. The wire which is colored blue must
be connected to the terminal which is marked with the
letter ‘N’ or colored black. The wire which is colored
brown must be connected to the terminal which is
marked with the letter ‘L’ or colored red.
WARNING : The appliance must be earthed.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked during
operation, the oven may overheat and eventually
cause a failure. For proper ventilation, allow above
76mm of space between oven sides, rear and the
minimum height of free space necessary above the
top surface of the oven is 100mm.
2. Steady, flat location
This oven should be set on a steady, flat surface.
This oven is designed for counter top use only.
The microwave oven shall not be placed in a cabinet
unless it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents
are covered during operation, the oven may
overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference may
result if the oven is located close to a TV, Radio
antenna, feeder and so on. Position the oven as far
from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash
when choosing a place to position it, or the insulation
might be adversely affected and breakdowns occur.
6. Power supply
• Check your local power source. This oven requires
a current of approximately 6 amperes, 230V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified on
this oven. Using a higher voltage may result in a fire
or other accident causing oven damage. Using low
voltage will cause slow cooking. We are not
responsible for damage resulting from use of this
oven with a voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
7. Examine the oven after unpacking for any damage
such as:
A misaligned door, Broken door, A dent in cavity. If
any of the above are visible, DO NOT INSTALL, and
notify dealer immediately.
8. Do not operate the oven if it is colder than room
temperature.
(This may occur during delivery in cold weather.)
Allow the oven to become room temperature before
operating.
DESUK_KOR6LC7WWUB015UW00,KOR6LC7WBUB015UB00,KOR6LC7WSUB015US00(영).indd 5
15. 11. 20. 오후 2:01