DAEWOO ELECTRONICS DWF-7570DP, Service Manual, Page: 25 / 42

DRAIN MOTOR AND VALVE REPLACEMENT
• Lay the front of the washer on the floor.
• Loosen the adjustment screw and four bolts
mounting the drain motor.
• Take out the wire of drain motor from the
bracket.
Drain motor
Wire
Bracket
BRAKE ADJUSTMENT
• Loosen the adjustment screw fastening the
bracket and place the adjustment screw to
the brake lever as shown in figure.
• Tighten the adjustment screw completely.
Brake lever
Adjustment screw
NOTE
1. The brake adjustment has been made at the factory, so that it is not to re-adjust. However, in case
of insufficient brake operation, perform the upper procedure.
2. Overtightening of the adjustment bolt will cause poor brake performance.
3. Undertightening of the adjustment bolt will cause continuous bracking and, thereby, cause the
problems of the motor during the spin cycle.
----------------------
24
• Separate the drain motor from the bracket.
Turn the valve lid by using screw driver as
shown in figure and remove the valve lid
from the valve frame.
Valve frame
Screw driver Valve lid
Pin
• Loosen the adjustment bolt and turn the
adjustment bolt until the end of the bolt
touches to the brake lever.
• Tighten the lock nut and apply a small
amount of paint-lock.
Bracket