●
EMS(Engine Management System)is
equipped with a self-diagnosis function
in order to ensure that the engine control
system is operation normally.
●
If this function detects a malfunction in
the system, the malfunction indicator
lamp immediately operates. It gives the
rider that malfunction has occurred in
the system.
●
Normally, the malfunction indicator
lamp illuminates for 3 seconds when the
main key is turned on. If the malfunction
indicator lamp does not come on under these
conditions, the malfunction indicator lamp
may be defective.
●
After 3 seconds, the malfunction indictor
lamp off automatically. However, the
MIL blinks continuously, check the EMS
system. If you are not able to check the
EMS system, contact your daelim dealers.
●
The EMS takes fail-safe function, it
enables to drive only temporary by
starting even on conditioned.
13
●
Running the engine beyond recommended
maximum engine speed(the beginning of
the tachometer red zone)can damage the
engine.
●
To avoid running out of fuel,it might cause
serve injury due to engine abruptly stop.
MIL
<
MALFUNCTION INDICATION LAMP
>
Indicates amount of gasoline in fuel tank.
If needle is within E mark,immediately fill
gasoline. Balance at this time is
approximately 4.0 litres.
<
TIME SETTLEMENT
>
Press the mode button for 2~3 seconds
(flickering) then adjust time using mode
button and ADJ button.
Summary of Contents for Roadwin 250R Fi
