●
Be sure to turn the ignition switch OFF
when replacing the bulb.
●
Do not use bulbs other than that
specified.
●
After installing a new bulb, check that
the light operates properly.
[HEADLIGHT BULB]
●
Before replacing the bulb, be sure to
check the switches for loose connection
of the connector.
1. Loosen the washer screws and remove
the headlight.
2. Pull off the socket without turning.
3. Loosen the pin and remove the bulb.
4. Install a new bulb in the reverse order
of removal.
HEADLIGHT BULB : 12V 35/35W
[POSITION LIGHT BULB]
1. Pull the position light socket and
remove it.
2. Pull out the bulb without turning
3. Install a new bulb in the reverse order
of removal.
POSITION LIGHT BULB : 12V 5W
47
BULB REPLACEMENT
WARNING
●
The light bulb becomes very hot while
the light is ON, and remain hot for a
while after it is turned OFF. Be sure to
let it cool down before servicing.
CAUTION
●
Do not put finger prints on the
headlight bulb, as they may create
hot spots on the bulb and cause it to
break. Wear clean gloves while
replacing the bulb.
If you touch the bulb with your bare
hands, clean it with a cloth moistened
with alcohol to prevent its early
failure.
POSITION LIGHT SOCKET
BULB
WIRE
SCREW
SCREW
SOCKET
BULB
HEADLIGHT UNIT
Summary of Contents for ROADWIN 125 FI
