DAELIM CITI ACE 110 -, Manual

Page: 24 / 68

Put vehicle in upright position on flat
ground and check engine oil level and
degree of pollution.
●
Run engine idle for approximately 2~3
minutes and stop engine.
Approximately 2~3 minutes thereafter,
check engine oil and verify the oil level
is between the upper and lower level of
oil level gauge.
●
Insert oil level gauge, without locking,
and check oil level after removing oil
gauge.
● If the oil level is near lower level,
replenish oil to upper level.
<HEADLIGHT, TAILLIGHT>
Start the engine and make sure the lights
turn on. Also check to see if the lights are
damaged or if there is dirt on them.
<BRAKE LIGHT CHECK>
Turn the main switch to ON.
While separately operating the front and
rear brakes, check to see if the brake light
turns on. Also check to see if there is any
damage to the lens or if there is dirt on the
brake light.
<WINKER CHECK>
Turn the main switch to ON.
Check to see if all the winker in the front
and rear of the vehicle (including left and
right sides) are flashing properly. At the
same time, check to make sure that the
automatic sound signal of the winker is
working. Check also to see if any of the
lens are damaged or dirty.
22
CAUTION
●
If air pressure is inadequate or if
there are cracks, damage or abnormal
wear on tires, it may cause trembling
steering wheel and flat tire.
● Insufficient air pressure may cause
the heavy steering wheel marking
handling difficult, fuel over cons-
umption and the excessive wear of
tire outer area and excessive air
pressure may cause easier wheel
handling and lower fuel cons-
umption. But it may also cause the
excessive wear of tire center area.
●
This motorcycle is equipped with
tubeless tires. If you have flat tires,
please contact authorised main-
tenance shops for inspection.
ENGINE OIL LEVEL CHECK LIGHTS AND WINKER
OIL LEVEL GAUGE
UPPER
LEVEL
LOWER
LEVEL