17
Installation Instructions
Step 15
Blower I/O port
Back of Hood
Front of Hood
Top of Hood
Back of Hood
Rotating the Blower(s) for Rear Exhaust
Orientating the Blower(s)
It is imperative that the blower(s) are installed in the
correct orientation.
To do this, make sure the
bower I/O port
is against the
back
of the hood. Confirm the placemet is correct by
comparing it with the figures on the right.
11. Roll the hood on its top so the tip of the blower can
extend beyond the exit vent.
12. Insert the blower into the exit vent with this specific
placement:
When standing at the
back of the hood
and
looking down at the blower:
• The blower I/O port must be on the right, and
• The blower I/O port must be against the back of
the hood.
Steps 11-12
Blower tip
extends here
Finalizing the Rear Vent Setup
13. Refasten the cable clamps and assembly to the hood.
14. Connect the cable assembly to the blower’s I/O port.
15. Attach the duct collars to the back of the hood.
16. Place the hood in a safe, upright position.
Summary of Contents for RNHP36 Renaissance
Page 31: ...29 Notes...
Page 32: ......
