20
Installation Instructions
WARNING
• To avoid electric shock or fire hazard, make sure that
power to the RNIVS power supply line is turned OFF
at the fuse box or circuit breaker before connecting
the electrical wiring.
• Miswiring the RNIVS electrical wiring can create an
electric shock or fire hazard and could damage the
RNIVS’ electrical system. See page 25-26.
• Do not ground the wires to the neutral (white) wire.
Connect the ground wire to a separate, properly
grounded ground-wire installed by a licensed electri-
cian.
• Make sure that all wire used is the correct gauge and
capable of handling the total connected loads and
meeting all codes.
Hardwiring the Hood
Control Panel Wire Diagram
L1
N1
Gnd
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
Not used
wires connected to hood
wiring harness, do not remove
wiring terminal inside unit
wires from in-line/remote
blower
remote blower series: REMP or ILHSF
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
To RNIVS
To Circuit Breaker
or Fuse Box
Junction Box
Junction Box Wire Diagram
The above right diagram shows how to wire the blower(s)
to the RNIVS control panel.
The lower right diagram shows how to hardwire the unit to
the home’s circuit breaker (main power source).
To Hardwire the RNIVS to the Main Power Source:
1. Follow the illustration at right called
Junction Box
Wire Diagram
.
