Dacor PGM365, Installation Instructions Manual

Page: 8 / 12

Page 6 Page 7
STEP 5
Connecting the Gas
Attach the gas pressure regulator (included with the cooktop) to cooktop pipe nipple inlet. For tight installations, the regulator may be installed
upstream from the pipe nipple, anywhere between the shut-off valve and the cooktop.
Install a gas shut-off valve (not included with the cooktop) in the main gas supply line in an accessible location near the cooktop. Complete
connection of the gas supply to the cooktop by installing 1/2 inch flexible gas line (not included with the cooktop) between the pressure
regulator and the shut-off valve.
IMPORTANT:
To prevent damage to the gas pressure regulator, install the regulator only after the cooktop is
mounted in its permanent position. Ensure that the arrow on the regulator points in the direction
of the gas flow towards the cooktop.
STEP 6
Installing the Burner and Grill Components
Grate
Burner Cap
Burner Ring
Top Frame
Burner Head (Fixed)
SGM Burner Components
Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages. Place each burner ring onto its
corresponding burner base, being certain that the five alignment tabs slide into the matching notches in the base. Set each porcelain burner
cap on top of its corresponding burner ring. Place each grate onto the cooktop, being certain that the rubber feet are positioned in the locating
dimples.
PGM Burner Components
Remove the brass burner heads, burner caps, and porcelain grates from their shipping packages. Place each burner head onto its
corresponding burner base, being certain that the alignment tabs slide into the matching notches in the base. Set each burner cap on top of its
corresponding burner ring. Place each grate onto the cooktop, being certain that the rubber feet are positioned in the locating dimples.
Grill Components
Remove the grill components from inside the main carton. Remove all of the packing materials from the Grill, U-burner, Heat Control Channels,
Grease Control Box and the Drip Pans.
Begin your set up by placing the Drip Pans inside on the bottom of the open grill burner box area, using the dimples to locate the Drip Pan.
Next, slip the open end of the U-burner onto the gas stub located in the front inside of the grill burner box, and insert the bracket on to opposite
end of the U-burner into the slot located on the Grease Control Box.
Proceed to install the Heat Control Channels, which sit on top of four pins at the inside front and back of the grease control box. Finally,
set the grill in place on the top of the cooktop.
WARNING:
Never attempt to operate the cooktop with any of the burner rings, burner caps, grates, or grill
components removed.
SGM Burner Components
NOTE:
The U-burner is adjusted at the factory and does not require any field adjustment for proper
function.
Grate
Dual Burner Cap
Dual Burner Head
Dual Burner
Cross Ring
Single Burner Base
Single Burner Head
PGM Burner Components