6
I
NSTALLATION
I
NSTRUCTIONS
R
EMOVING THE
P
ACKAGING
1
Cut the shipping carton and use it as a pad beneath
the dishwasher. This will protect the finished floor in the
kitchen.
2
Remove wrapping and uncoil the drain hose in the back of
the dishwasher. Do not remove the rear insulation blanket.
3
Lay the dishwasher on its back. Do not kink or crush the
drain hose.
I
NSTALLING THE
L
EVELING
L
EGS
1
Measure the installation opening from the floor to the
bottom of the countertop.
2
Install the leveling legs into the holes below the red
plugs. Use the spanner wrench to screw the legs in until
the overall height of the dishwasher is 1/4” less than the
installation opening height. See Figure 9.
3
Remove the red shipping plugs.
NOTE:
Install the legs as shown a minimum of 1-1/4” from the
bottom of the brackets.
R
EMOVING THE
F
OAM
M
OTOR
S
UPPORT
1
Locate the wedge of polystyrene (foam) from between the
motor and the liner. See Figure 10.
2
Use two hands to rotate and slide the foam down and to
the left to remove it.
3
Discard the foam.
R
EMOVING THE
A
CCESS
C
OVER
1
Remove the four (4) screws at the front of the access
cover. See Figure 11.
2
Tilt access cover and pull forward to remove.
3
Pull house wiring into junction box. Use a UL listed strain-
relief bushing at the junction box to stabilize wiring.
FIG 9
FIG 10
FIG 11
FOAM SUPPORT
CAUTION
CAUTION– Failure to install the legs correctly may result in
damage to the door when opened.